Columbus Elevator Buckets

Columbus Elevator Buckets

The Columbus elevator bucket is according to DIN15232 and available in pressed (stainless) steel and plastic PE (white)/Nylon (green).

This product is also commonly referred to as or can be compared to: Pressed elevator bucket, System CB

Columbus Steel

The steel buckets are seamlessly pressed from one piece and are available in an ST 37 version as well as in stainless steel 1.4301 / 1.4401 / 1.4571. These cups are equipped with standard recessed holes. Buckets with deviating holes or without holes are also available at short notice.

Z3 = net Volume in liters

The buckets are available in different thicknesses t = 2,5 and 3,0 mm.

Please note the holes can differ from DIN 15232.

Columbus Plastic

The Columbus elevator buckets made of plastic are better suited for conveying wet or sticky materials and are available in two versions. The white HDP version can withstand maximum temperatures of 60 ° C. The green Columbus elevator beaker made of nylon is heat resistant up to a maximum temperature of 90 ° C. The following table shows the standard sizes of the Columbus elevator buckets made of plastic. Please pay attention to the possibly different hole distances to the steel cups.

Z3 = net Volume in liters

Columbus elevator buckets are available in HDPE (white) and Nylon (green).

Please note the holes can differ from the steel Columbus elevator buckets.

View our calculations for Elevator Parts

Elevator Parts